| Item | Specification |
| Input | Input voltage | 1phase/3phase 220V:200V-240V 3phase 400V:380V-480V |
| Allowed Voltage fluctuation range | -15%～10% |
| Input frequency | 50Hz / 60Hz,fluctuation less than 5% |
| Input filter | SIZE C and above with built in DC reactor |
| Output | Output voltage | 3phase:0～input voltage |
| Overload capacity | 150% rated output current for 60s；180% rated output current for 10s；200% rated output current for 2.0s |
| Control | Control mode | V/f control Sensorless vector control (SVC) Vector control with speed sensor (VC) |
| Operating mode | Speed control,torque control(SVC ;VC),position servo |
| Speed range | 1:100(V/f) 1:200(SVC) 1:1000(VC) |
| Speed control accuracy | ±0.5%(V/f) ±0.2%(SVC) ±0.01%(VC) |
| Frequency range | 0.00～600.00Hz(standard) 0.0～2000.0Hz(higher standard) |
| Input frequency resolution | Digital input:0.01Hz or 0.01% Analog input:The maximum frequency is 0.025% |
| Startup torque | 150%/0.5Hz(V/f) 180%/0.25Hz(SVC) 180%/0Hz(VC) |
| Torque control accuracy | SVC:5Hz within 8%,5Hz above 5% VC:3.0% |
| Frequency giving ramp | Support linear and S curve acceleration and deceleration; 4 groups of acceleration and deceleration time, setting range 0.00s ~ 60000s |
| Position control | The position command supports internal position, pulse position input, CAN open position command, Ethercat position command (VFD586). Support position full closed loop mode |
| DC bus voltage control | Overvoltage stall control: limit the power generation of the motor by adjusting the output frequency to avoid skipping the voltage fault; Undervoltage stall control: control the power consumption of the motor by adjusting the output frequency to avoid skipping the voltage fault； |
| Carrier frequency | 1kHz～16kHz(Varies depending on the type) |
| Startup method | Direct start (can be superimposed DC brake); speed tracking start |
| Stop method | Deceleration stop (can be superimposed DC braking); free to stop |
| Special functions | Built-in delay unit, comparison unit and logic unit, etc., two groups of motor parameter switching, software switching output phase sequence, spindle orientation, online identification of motor parameters |
